Vol. 337 No. 8 (2026)
DOI https://doi.org/10.18799/24131830/2026/8/5058
Development of a model of a cooling system for a power oil transformer based on sulfur hexafluoride
Relevance. New type of cooling of a power oil transformer with SF6 bubbles is proposed and therefore it is necessary to develop a mathematical model for selecting the optimal operating mode of a compressor bubbling SF6 gas. In the process of overheating of a power oil transformer, a cooling system is activated using floating SF6 bubbles, as a result, the pressure in the working area decreases, it becomes lower than the saturation pressure of the transformer oil with SF6 gas, i. e. when SF6 gas passes through the transformer oil inside the working area, an area of heat exchange of transformer oil, SF6 gas and transformer windings occurs. In this situation, each of the phases has a decisive effect on the creation of a thermal field in the working area, due to the manifestation of thermodynamic effects and the heat of degassing of the transformer oil. The formation of the temperature field is affected by various parameters: the local initial temperature on the transformer windings, the content of dissolved SF6 gas in the transformer oil, as well as the ratio of pressures in the transformer oil reservoir and the saturation pressure of the transformer oil with SF6 gas, etc. Thermal processes provide information on the current state of the power oil transformer. Aim. To formulate and solve the temperature problem of the transformer oil cooling. The object of the study is an industrial power oil transformer and a gas-insulated cooling system. Methods. One of the key aspects of ensuring the safety and efficiency of power oil transformers is the analysis of their temperature conditions. Under normal and especially emergency conditions of transformer operation, especially in gas-insulated cooling systems, transformer oil decomposes, which leads to gas formation. These processes cause changes in the temperature distribution inside the transformer, providing valuable data for diagnosing the causes of accidents. Results. The author has determined the dependences of temperature conditions on the operating time and operating conditions, which served as the basis for software development. Based on the identified patterns of heat transfer by SF6 gas in liquid insulators, it is possible to develop industrial solutions with adjustable diffusion and heat transfer parameters, as well as optimize the operating modes of these systems, taking into account the dynamics of chemical reactions and their rates. This allows for increased reliability and efficiency of transformer equipment operation.
For citation: Khismatullin A.S. Development of a model of a cooling system for a power oil transformer based on sulfur hexafluoride. Bulletin of the Tomsk Polytechnic University. Geo Assets Engineering, 2026, vol. 337, no. 8, pp. 16–23. https://doi.org/10.18799/24131830/2026/8/5058
Keywords:
bubbling, SF6 gas, temperature, transformer, gas content
References:
1. Aganin A.A., Davletshin A.I., Khalitova T.F. Numerical simulation of bubble dynamics in central region of streamer. Multiphase Systems, 2018, vol. 13, no. 3, pp. 11–22. (In Russ.) Available at: http://mfs.uimech.org/2018/mfs2018.3.pdf (accessed 15 February 2025).
2. Gubaidullin D.A., Kabirov A.A., Shaydullin L.R., Fadeev S.A. Temperature field during nonlinear gas oscillations in a channel of rectangular cross-section. Thermophysics of high temperatures, 2022. vol. 60, no. 6, pp. 884–887. DOI: 10.31857/S0040364422050064
3. Nigmatulin R.I., Akhatov I.Sh., Vakhitova N.K. Forced oscillations of a gas bubble in a spherical volume of compressible fluid. Applied Mathematics and Mechanics, 1999, vol. 40, no. 2, pp. 111–118. (In Russ.) Available at: https://www.sibran.ru/upload/ iblock/8c7/8c706cbb04428861e202eff2f4ffb5db.pdf (accessed 15 February 2025).
4. Aganin A.A., Aganin I.A., Davletshin A.I., Nigmatulin R.I. Response of gas bubbles in spherical clusters to a single rarefaction pulse. High Temperature Thermophysics, 2023, vol. 61, no. 1, pp. 98–107. (In Russ.). DOI: 10.31857/S0040364423010131.
5. Kartashov E.M. Generalized model representation of the thermal shock theory. Math Models Comput Simul, 2023, 15 (Suppl 1), pp. 86–95. DOI: https://doi.org/10.1134/S2070048223070062
6. Filippov A.I., Khismatullin A.S., Mukhametzyanov E.V., Leontyev A.I. Thermal transcillator of a traveling wave. Bulletin of Moscow State Technical University. N.E. Bauman. Series Natural Sciences, 2011, no. 1 (40), pp. 78–86. Available at: https://cyberleninka.ru/article/n/prodlenie-resursa-maslyanyh-transformatorov-s-dlitelnym-srokom-ekspluatatsii (accessed 15 February 2025).
7. Aganin A.A., Davletshin A.I. А Particle model of interaction between weakly non-spherical bubbles. Applied Mathematical Modelling, 2024, no. 126, pp. 185-205. DOI: https://doi.org/10.1016/j.apm.2023.10.031
8. Nigmatulin R.I., Aganin A.A., Aganin I.A. et al. Dynamics of Bubbles in a Spherical Cluster under Increasing Liquid Pressure. High Temperature, 2023, no. 61, pp. 681–688. DOI: https://doi.org/10.1134/S0018151X23050103.
9. Aganin A.A., Ilgamov M.A., Toporkov D.Yu. Possibility of increasing the liquid temperature in the problem of supercompression of a bubble by an acoustic action. Scientific Notes of Kazan University. Series: Physical and Mathematical Sciences, 2019, vol. 161, no. 4, pp. 485–496. (In Russ.)
10. Khismatullin A.S., Vakhitov A.Kh., Feoktistov A.A. Transformer oil cooling system based on transcillatory heat transfer. Energy Safety and Energy Saving, 2016, no. 4, pp. 43–46. (In Russ.)
11. Khismatullin A.S., Surakov M.R., Syntimirov A.A. Increasing the cooling of oil power transformers by bubbling SF6 gas bubbles. Engineering Physics, 2017, no. 6, pp. 27–31. (In Russ.)
12. Krivokoneva O.O., Kudoyarov R.I., Mavlekaev E.Yu., Konys E.M., Prakhov I.V. Extending the life of oil transformers with a long service life. Bulletin of the South Ural State University. Series: Energy, 2017, vol. 17, no. 3, pp. 60–66. (In Russ.)
13. Bashirov M.G., Gribovsky G.N., Gallyamov R.U., Khismatullin A.S. Application of automatic control mode of power supply of industrial site of linear-production control of main gas pipelines. New in Russian electric power industry, 2016, no. 6, pp. 28–35. (In Russ.)
14. Gadzhiev M.Kh., Tyuftyaev A.S., Ilyichev M.V. Single bubble of electronegative gas in transformer oil under the influence of electric field. Journal of Technical Physics, 2017, vol. 87, no. 10, pp. 1493–1497. DOI: 10.21883/JTF.2017.10.44992.2163
15. Gadzhiev M.Kh., Tyuftyaev A.S., Akimov P.L., Sargsyan M.A., Demirov N.A. Investigation of the electric breakdown in a two-phase mixture of transformer oil and gas bubbles. Applied Physics, 2016, no. 5, pp. 10–15. Available at: https://www.researchgate.net/publication/316509420 (accessed 15 February 2025).
16. Miyagi K., Fujita R., Ou I., Hanaoka R., Matsushita K. and Wakimoto K. Characteristics of the inter-section insulation transformer winding model with esters under short-tailed impulse voltages. 23rd International Symposium on High Voltage Engineering (ISH 2023). Glasgow, UK, 2023. pp. 900–905. DOI: 10.1049/icp.2024.0696.
17. Nedospasov A.V., Isakaev E.Kh., Tyuftyaev A.S., Gadzhiev M.Kh. On the influence of single gas bubbles on the electrical breakdown of transformer oil. Journal of Technical Physics, 2015, vol. 85, no. 7, pp. 142–143. (In Russ.) DOI: 10.1134/S1063784215070191.
18. Gadzhiev M.Kh., Tyuftyaev A.S., Ilyichev M.V. Single bubble of an electronegative gas in transformer oil in the presence of an electric field. Journal of Technical Physics, 2017, vol. 87, no. 10, pp. 1493–1497. (In Russ.) DOI: 10.1134/S1063784217100103
19. Khvostov A.A., Ivanov A.V., Zhuravlev A.A., Boger A.A. Optimization of the operating modes of the rectification column of the air separation unit. Mathematical methods in technology and engineering, 2021, no. 2, pp. 16–19. (In Russ.). DOI: 10.52348/2712-8873_MMTT_2021_2_16.
20. Zhang H., Gang L., Lin B., Deng H., Li Y., Wang P. Thermal evaluation optimization analysis for non‐rated load oil‐natural air‐natural transformer with auxiliary cooling equipment. IET Generation, Transmission & Distribution, 2022, vol. 16, no. 15, pp. 3080–3091. DOI: https://doi.org/10.1049/gtd2.12502
21. Akbari M., Mostafaei M., Rezaei-Zare A. Estimation of hot-spot heating in oip transformer bushings due to geomagnetically induced current. IEEE Trans. Power Deliv, 2023, no. 38 (2), pp. 1277–1285. DOI: https://doi.org/10.1109/TPWRD.2022.3212322
22. Hrytsiuk I., Volynets V., Komenda N., Hrytsiuk Yu., Hadai A. Modelling the optimal switching scheme of the Ukrainian power grid during blackout (Volyn region). Machinery & Energetics, 2024, vol. 15, no 2, pp. 95–105. DOI: 10.31548/machinery/2.2024.95
23. Bohra S.S., Anvari-Moghaddam A. A comprehensive review on applications of multicriteria decision-making methods in power and energy systems. International Journal of Energy Research, 2022, no. 46 (4), pp. 4088–4118. DOI: 10.1002/er.7517
24. Jing L., Xueqing D., Chao Y., Wei F., Tong L., Liang W. Research on finite element reduced order modeling method of transformer temperature field for digital twin application. High Voltage Engineering, 2023, no. 49 (6), pp. 2408–2419. DOI: 10.13336/j.1003-6520.hve.20220689
25. Chen X., Huang Y., Xu S. Thermal performance evaluation of electronic fluorinated liquids for single-phase immersion liquid cooling. International Journal of Heat and Mass Transfer, 2024, vol. 220, no. 124951. DOI: 10.1016/j.ijheatmasstransfer.2023.124951
26. Luo Q., Chen W., Zheng Ju., Wang Ch. Experimental and numerical study of structural parameters on the heat transfer performance of submerged cooling system. Applied thermal engineering, 2024, no. 256, 123727 р. DOI: 10.1016/j.applthermaleng. 2024.123727
27. Zhang X., Daghrah M., Wang Z.D., Liu Q., Jarman P., Negro M. Experimental verification of dimensional analysis results on flow distribution and pressure drop for disc type windings in OD cooling modes. IEEE Trans. Power Delivery, 2018, no. 33 (4), pp. 1647–1656. DOI: 10.1109/TPWRD.2017.2739483
28. Zhang X., Wang Z.D., Liu Q. Interpretation of hot spot factor for transformers in OD cooling modes. IEEE Trans. Power Delivery, 2017, no. 33 (3), pp. 1071–1080. DOI: 10.1109/TPWRD.2017.2710087
29. Zhang X., Wang Z., Liu Q., Jarman P., Negro M. Numerical investigation of oil flow and temperature distributions for ON transformer windings. Appl. Therm. Eng., 2018, no. 130, pp. 1–9. DOI: 10.1016/j.applthermaleng.2017.10.092
30. Zhang X., Wang Z., Liu Q. Prediction of pressure drop and flow distribution in disc type transformer windings in an OD cooling mode. IEEE Trans. Power Delivery, 2017, no. 32 (4), pp. 1655–1664. DOI: 10.1109/TPWRD.2016.2557490
31. Khismatullin A.S. Development of measures to optimize the transformers loading. International Conference on Industrial Engineering, Applications and Manufacturing (ICIEAM), 2022. pp. 1014–1018, DOI: 10.1109/ICIEAM54945.2022.9787182.
32. Torriano F., Campelo H., Quintela M., Labbé P., Picher P. Numerical and experimental thermofluid investigation of different disc-type power transformer-winding arrangements. Int. J. Heat Fluid Flow, 2018, no. 69, pp. 62–72. DOI: 10.1016/j.ijheatfluidflow.2017.11.007.
33. Daghrah M., Wang Z., Liu Q., Hilker A., Gyore A. Experimental study of the influence of different liquids on the transformer cooling performance. IEEE Trans. Power Delivery, 2019, no. 34 (2), pp. 588–595. DOI: 10.1109/TPWRD.2019.2895533.
34. Khismatullin A.S., Devyatkin E.M., Poberezhkii S.Y. Mathematical modeling of the temperature field during the filtration of carbonated liquid. International Russian Automation Conference (RusAutoCon). Sochi, Russian Federation, 2024. pp. 977–981, DOI: 10.1109/RusAutoCon61949.2024.10694305.
